Latest Cisco 300-515 Dumps for success in Actual Exam Oct-2023]
Realistic 300-515 100% Pass Guaranteed Download Exam Q&A
NEW QUESTION # 22
Refer to the exhibit:
A network engineer is implementing an OSPF configuration Based on the output, which statement is true?
- A. OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
- B. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
- C. IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway
- D. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
Answer: A
NEW QUESTION # 23
An engineer is investigating an EVPN traffic flow issue. Which type of traffic should the engineer allow in an EVPN Tree Service in order to fix this issue?
- A. multicast from a leaf to another leaf
- B. known unicast from a root to another root
- C. unknown unicast from a leaf to another leaf
- D. known unicast from a leaf to another leaf
Answer: B
Explanation:
Reference:
https://tools.ietf.org/html/draft-ietf-bess-evpn-etree-14
NEW QUESTION # 24
Which BGP feature causes to replace the AS number of originating router with the AS number of the sending router?
- A. confederations
- B. AS override
- C. route dampening
- D. route reflectors
Answer: B
Explanation:
Reference:
<https://community.cisco.com/t5/networking-documents/understanding-bgp-as-override-feature/ta- p/3111967>
NEW QUESTION # 25
Refer to the exhibit.
An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?
- A. transit
- B. source
- C. headend
- D. bud
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/mpls/mp-te-path-setup- xe-3s-asr920-book/mp-te-path-setup-xe-3s-asr920-book_chapter_01.html
NEW QUESTION # 26
Which two statements about implementing a separate MPLS VPN to provide customers Internet access are correct? (Choose two.)
- A. Customers are assigned to the Internet VPN.
- B. The Internet gateway router will act as a CE router.
- C. Internet routes will be leaked from the PE global routing table to the customer VRF.
- D. Customers will use separate interfaces for VPN and Internet access.
Answer: A,B
NEW QUESTION # 27
Which tool identifies the point of failure in a P2MP LSP from the ingress LSR?
- A. P2MP ping
- B. P2MP traceroute
- C. SPAN
- D. Jitter TLV
Answer: B
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r5-3/mpls/configuration/ guide/b-mpls-cg53x-asr9k/b-mpls-cg53x-asr9k_chapter_01000.html
NEW QUESTION # 28
What do EVPN single-active and all-active have in common?
- A. They are used to provide single connection from a CE device to a service provider.
- B. They are default gateway redundancy options.
- C. They are multihoming mechanisms used for CE devices.
- D. They are both roles that a designated router can take when MPLS is used with EVPN.
Answer: D
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-2/lxvpn/configuration/ guide/b-l2vpn-cg-asr9000-62x/b-l2vpn-cg-asr9000-62x_chapter_01011.html
NEW QUESTION # 29
Refer to the exhibit.
What is shown in this output?
- A. the labels received and advertised on PE1
- B. LDP neighbor statuses
- C. local and outgoing abels are updated in hardware
- D. BGP is used between neighbors that are exchanging MPLS labels
Answer: A
NEW QUESTION # 30
Which two frames can be configured on an Ethernet flow point? (Choose two.)
- A. of a specific VLAN
- B. with different type of service values
- C. with identical type of service value
- D. with no tags
- E. with different class of service values
Answer: A,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/cether/configuration/xe-3s/asr903/16-5-1/b-ce-xe-16-5-asr900/trunk-efp-support.html
NEW QUESTION # 31
When implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers, which PE-to-CE routing protocol requires a separate routing process to be created for each VRF?
- A. EIGRP
- B. OSPF
- C. RIPv2
- D. BGP
Answer: B
NEW QUESTION # 32
Refer to the exhibit. A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)
- A. Type 2 routes contain inclusive source-specific multicast route information.
- B. Type 2 routes contain Ethernet Auto-Discovery information.
- C. Type 2 routes contain MAC/IP information.
- D. The operator adds in "host-routing" under the BVI651 interface.
- E. The operator adds in "host-routing" under the VRF EVPN.
Answer: C,D
NEW QUESTION # 33
Refer to the exhibit.
An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?
- A. transit
- B. source
- C. headend
- D. bud
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/mpls/mp-te-path-setup- xe-3s-asr920-book/mp-te-path-setup-xe-3s-asr920-book_chapter_01.html
NEW QUESTION # 34
Which two statements describe primary differences between MPLS Layer 2 and Layer 3 VPNs?
(Choose two.)
- A. Layer 2 VPNs use IPsec tunneling, but Layer 3 VPNs use L2TPv3 tunneling.
- B. Layer 2 VPNs use L2TPv3 tunneling, but Layer 3 VPNs use GRE tunneling.
- C. Layer 2 VPNs use IPsec tunneling, but Layer 3 VPNs use pseudowires to provide tunneling.
- D. Layer 2 VPNs use BGP, but Layer 3 VPNs use VPLS.
- E. Layer 2 VPNs use AToM, but Layer 3 VPNs use MPLS/BGP.
Answer: B,E
NEW QUESTION # 35
Which kind of traffic is supported in an MVPN Extranet?
- A. PIM dense mode with Reverse Path Forwarding
- B. PIM dense mode
- C. PIM sparse mode
- D. Bidirectional PIM
Answer: C
NEW QUESTION # 36
Refer to the exhibit:
A network engineer is implementing an OSPF configuration Based on the output, which statement is true?
- A. OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
- B. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
- C. IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway
- D. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
Answer: A
NEW QUESTION # 37
An ISP provides a major client MPLS VPN for managed services. The MPLS engineering team needs to use the advanced VPN feature of selective VRF import so that only specific prefixes are present in the required VPNs.
Which aspect of this feature must the team consider?
- A. The routers that are imported in the VRF can be BGP and IGP routes, so other match conditions in the route map, besides communities, can be used.
- B. The import-map command is applied under the PE interface that connects to the CE router.
- C. A route must pass the import route map first and then the route target import filter.
- D. A route is imported into the VRF only when at least one RT that is attached to the route matches one RT that is configured in the VRF and the route is permitted by the import route map.
Answer: D
Explanation:
Reference: https://www.ccexpert.us/mpls/configuring-selective-vrf-import.html
NEW QUESTION # 38
Refer to the exhibit.
PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration? (Choose two.)
- A. All three routers must be running a distance-vector routing protocol.
- B. The CE1 and CE2 VRFs can access the default route provided by the Internet VRF.
- C. All three routers must be running MP-BGP.
- D. Only the CE2 VRF can access the default route provided by the Internet VRF.
- E. The CE1 and CE2 VRFs can exchange routes only between their respective VRFs on PE1 and PE2.
Answer: C,E
NEW QUESTION # 39
Refer to the exhibit. An engineer is trying to configure an EVPN VWPS. What is the issue with this configuration?
- A. The service instance and the EVPN instance are different.
- B. The member in the VPWS context should be the PE-facing interface.
- C. Interface GigabitEthernet0/1/0 should not have any IP address.
- D. The 12vpn evpn command should be instance 101.
Answer: C
NEW QUESTION # 40
DRAG DROP
Drag and drop the EVPN components from the left onto the correct planes on the right.
Select and Place:
Answer:
Explanation:
Section: Layer 2 VPNs
Explanation/Reference: https://www.cisco.com/c/dam/m/en_us/network-intelligence/service-provider/digital- transformation/knowledge-network-webinars/pdfs/0420-epn-ckn.pdf slide 8
NEW QUESTION # 41
Refer to the exhibit.
Drag and drop the EVC configuration items from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 42
Which optional information can be included with an IPv6 ping to support the troubleshooting process?
- A. destination MAC address
- B. source MAC address
- C. IPv4 IP address
- D. IPv6 hostname
Answer: D
Explanation:
Reference:
<https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6/configuration/xe-3s/ipv6-xe-36s-book/ip6- mng-apps.html>
NEW QUESTION # 43
Which statement describes the no bgp default route-target filter
- A. Prefixes that are received with route targets that are not imported at the PE are not accepted.
- B. Prefixes that are received with route targets and distinguisher are accepted.
- C. Prefixes that are received with route targets and distinguisher are not accepted.
- D. Prefixes that are received with route targets that are not imported at the PE are accepted.
Answer: D
NEW QUESTION # 44
......
Cisco 300-515: Implementing Cisco Service Provider VPN Services certification exam is an excellent choice for individuals who want to enhance their knowledge and skills in implementing VPN services in a service provider environment. Implementing Cisco Service Provider VPN Services certification will help candidates to validate their expertise in VPN technologies and increase their job prospects in the IT industry.
Cisco 300-515 certification exam is designed to validate the expertise of individuals in implementing Cisco service provider VPN services. Implementing Cisco Service Provider VPN Services certification is intended for professionals who work in service provider organizations and are involved in implementing VPN services. 300-515 exam covers a wide range of topics, including VPN architecture, MPLS-based VPNs, Layer 2 and Layer 3 VPNs, and VPN security.
To prepare for the Cisco 300-515 exam, candidates can take advantage of a range of study materials provided by Cisco, including online courses, books, and practice exams. Hands-on experience with Cisco IOS XR routers and Cisco ASR 9000 Series routers is also recommended. Candidates who pass the exam will receive the Cisco Certified Specialist - Service Provider VPN Services Implementation certification, which demonstrates their expertise in implementing VPN services in a service provider network.
Accurate 300-515 Answers 365 Days Free Updates: https://prepaway.testkingpass.com/300-515-testking-dumps.html